DEQX A250X3 Power Amplifier

Electrical Disclaimer Further Information

This is for 3 x A250X3. I was using these for my active stereo VAF I66 and active VAF I66 center channel so there are nine channels in total. Each amplifier has 2 x 250W @ 4ohms and 1 x 100W @ 4ohms. The hypex amplifier modules are used. There is a trigger and only has XLR balanced inputs. Send me a message if you have any questions. Specifications are below.

A250X2 AND A250X3 Parameter Bass/midrange (A250x3) CH-1/CH-2 (A250x2) Tweeter (A250x3 only) Input impedance 47 kΩ 47 kΩ Voltage gain 25.5 dB 25.5 dB Input voltage for full power (4 ohms) 1.7 V RMS 1.05 VRMS Input voltage for full power (8 ohms) 2.1 V RMS 1.5 V RMS Distortion <10Hz-20kHz AES17 Pout=1W < 0.0015% < 0.0018% Damping factor f < 20 kHz, Load = 4Ω > 1000 > 1000 Frequency response, +0/-3 dB 10 Hz to 50 kHz 10 Hz to 50 kHz1 Signal to noise ratio <10Hz-20kHz AES17 121 dB 106 dB Minimum speaker impedance 2 Ω 2 Ω Max output power (4 ohms) 1KHz, THD=1%, both channels driven 250 WRMS 100 WRMS Max output power (8 ohms) 1KHz, THD=1%, both channels driven 200 WRMS 100 WRMS Continuous/average output power Thermally limited, 25°C ambient 50 WRMS 20 WRMS Maximum power consumption 650 W

WARRANTY INFORMATION (Private Seller)

The item being advertised is sold "as is", and no warranty should be assumed unless otherwise indicated and agreed between the Buyer and the Seller. Photos representing the item being advertised form part of the description unless otherwise specified.